Calais L4-151 2.5L VIN U TBI (1989)
These changes increase the rate of fluid exhausted through the Manual Valve during cold operating conditions, which reduces the potential for delayed
engagement when shifting from Reverse to Drive.
DATE OF PRODUCTION CHANGE:
June 12, 1989, (Julian Date 163), the new Manual Valve and Thermal Orifice Assembly went into production.
SERVICE PROCEDURE:
The new Manual Valve and Thermal Element assembly can be used on all past models. If replacement of the Manual Valve is necessary, the new Manual
Valve (cross drilled) and Thermal Orifice must be used together.
SERVICE PARTS INFORMATION:
When ordering a new Manual Valve and Thermal Orifice, refer to the following number:
Part Number
Description
8666494
Assembly, Manual Valve with Thermal Orifice
Parts are currently available from GMSPO.
SERVICE MANUAL REFERENCE:
Whenever servicing a THM 125C/HYDRA-MATIC 3T40 for this condition, refer to the procedure given in the 125C/HYDRA-MATIC 3T40 Unit
Repair Section of your Service Manual.
SERVICE NOTES:
The retainer clip for the temperature orifice must be 11.2 mm +/- 0.2 mm (0.44" +/- .008") inside the link end of the Manual Valve for proper operation.
If the Thermal Element has moved forward due to a retaining clip that has fallen out, the vehicle may exhibit a loss of Drive and/or Reverse. A clip that
has fallen out may be located in the bottom pan.
WARRANTY INFORMATION:
Labor Operation Number:
K7500
